Хмм, видимо флеш вылетел. Перезаливка IOS чз XModem оживила роутер. Теперь выдаётся:
System Bootstrap, Version 11.1(19)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Copyright © 1998 by cisco Systems, Inc.
C3600 processor with 65536 Kbytes of main memory
Main memory is configured to 32 bit mode with parity disabled
get_man_dev: Unknown device - probably NOT formatted.
get_man_dev: Unknown device - probably NOT formatted.
program load complete, entry point: 0x80008000, size: 0xe5f6b8
Self decompressing the image : ########################################################################################################################################################################################## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
000037 0X00056400 Combination Single Ethernet 2 WAN
0X00098670 public buffer pools
0X00211000 public particle pools
TOTAL: 0X002FFA70
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 3Mb.
adjusted iome size up to minimum size of: 0X00400000
Using 6 percent iomem. [4Mb/64Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
© of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
© (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS ™ 3600 Software (C3620-IK9O3S7-M), Version 12.3(16), RELEASE SOFTWARE (fc4)
Technical Support:
http://www.cisco.com/techsupportCopyright © 1986-2005 by cisco Systems, Inc.
Compiled Wed 24-Aug-05 02:15 by ssearch
Image text-base: 0x60008B00, data-base: 0x6193C000
%Error: System flash bank 3 chip 2 unknown, chip id 0x90FF (reversed = 0x9FF )
%Error: System flash initialization failed
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.htmlIf you require further assistance please contact us by sending email to
[email protected].
cisco 3620 (R4700) processor (revision 0x81) with 61440K/4096K bytes of memory.
Processor board ID 08883292
R4700 CPU at 80MHz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Press RETURN to get started!
%Error: System flash bank 3 chip 2 unknown, chip id 0x90FF (reversed = 0x9FF )
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
%Error: System flash initialization failed
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
